contact details

Anshan Heli Laser Equipment Co., Ltd.

National Service Hotline : 400-641-6888

Address: No. 368 Qianshan Road, High-tech Zone, Anshan City

Dongguan Heli Laser Equipment Co., Ltd.

Address: No. 48 Wenxiang Road, Xiaoxiang, Wanjiang District, Dongguan City, Guangdong Province

Phone: 0769-88879968

0769-21661919

Fax: 0769-21665152

Contact: Mr. Yang

Mobile: 13609678851

E-mail: info@afeweb.com

Under what circumstances should the output power of a laser cutting machine be increased? You are here: 杏鑫平台 - Company News - Laser Equipment Knowledge

Under what circumstances should the output power of a laser cutting machine be increased?

Release time: 2014.09.15 News source: Views:

Analyze why the laser cutting machine has errors:
1. The laser cutting machine processing parameters are set incorrectly. To reset the correct processing parameters.
2. The signal line of the laser cutting machine is abnormal. You need to replace the signal cable.
3. The computer is not running normally. You need to repair or replace the computer.
4. Poor grounding of laser cutting machine equipment and computer. In this case, the equipment and computer need to be well grounded.
5. The laser cutting machine processing program was written incorrectly. The machining program needs to be checked and repaired.
6. The computer operating system is faulty or infected with a virus. Need to reinstall the operating system or perform virus killing.
7, laser cutting machine power supply is unstable or caused by interference signals. At this time, you need to install a voltage regulator or eliminate interference signals.
8. The laser cutting machine application software is abnormal. At this time, you need to reinstall the software and the driver software of the motion control card.

In some cases, it is necessary to increase the output power of the laser cutting machine :
1. Adding high-density and high-hardness materials requires very high performance of the laser cutting machine . It can be solved by increasing the laser output power and reducing the cutting speed to achieve the effect.
2. When the cutting speed of the laser cutting machine is too slow, the laser output power can be appropriately increased to increase the cutting speed.
3. For some special materials, when the short focal length lens needs to be replaced with a long focal length lens, the laser output power needs to be increased.
4. When the thickness of the cutting material is too high, you can increase the laser output power through the control panel to improve the cutting performance.

This article is divided into 1 pages
share to:
Previous: The new version of the Hong Kong and Macao Permit has achieved significant improvements in security and anti-counterfeiting and laser anti-counterfeiting technology
Next: The 11th Optical Expo and the 10th China Hubei Industry-University-Research Cooperation Project Fair will be held at Wuhan International Expo Center from November 6th to 8th, 2014
related articles:
    No Information