contact details

Anshan Heli Laser Equipment Co., Ltd.

National Service Hotline : 400-641-6888

Address: No. 368 Qianshan Road, High-tech Zone, Anshan City

Dongguan Heli Laser Equipment Co., Ltd.

Address: No. 48 Wenxiang Road, Xiaoxiang, Wanjiang District, Dongguan City, Guangdong Province

Phone: 0769-88879968

0769-21661919

Fax: 0769-21665152

Contact: Mr. Yang

Mobile: 13609678851

E-mail: info@afeweb.com

您的位置: 首页 - 公司动态 - 激光设备知识 There are four points to note about the maintenance of fiber laser marking machine. Your location: 杏鑫平台 - Company News - Laser Equipment Knowledge

There are four points to note about the maintenance of fiber laser marking machine

Release time: 2015.09.02 News source: Laser cutting machine | Laser marking machine | Laser engraving machine | Fiber laser marking machine | Laser equipment manufacturer-Dongguan Heli Laser Equipment Co., Ltd
First of all, keep the room and the surface of the machine clean and tidy regularly to check whether each optical lens is dirty (the deadline depends on the working environment). If there is any dirt, scrub it in case of emergency. Scrubbing method: When cleaning the lens, you must be very careful. Before the lens is cleaned, it is strictly forbidden to arbitrarily modify the protection circuit and the main components of the laser;
Secondly, it is strictly forbidden to start the laser power supply and Q-switched power supply in the absence of water or abnormal water circulation. Do not allow the Q-power supply to work without load (that is, the Q-switched power output is suspended). Check that the laser power output (anode) is suspended to prevent fire and breakdown with other electrical appliances;
Then, keep the internal circulating water clean. Regularly clean the laser marking machine water tank and change the deionized water or pure water. It is not allowed to start other components before the cymbal lamp is ignited to prevent high pressure from entering the damaged components;
Finally, the laser chiller is configured to effectively cool the module and Q head of the marking machine to prevent the marking machine from overheating. In the process of use, the above matters should be observed and the laser equipment used correctly, so as to prolong the service life of the equipment and reduce the cost.


This article is divided into 1 pages
share to:
Previous: 3D Flying Weaving Upper Leather Automatic Laser Cutting Machine
Next: To share with you the working principle of laser marking machine galvanometer
related articles:
    No Information